Advertisement
SEATS
15-45
Removal and Installation
1. Remove second seat cushion.
2. Move folding second seat back forward just
sufficiently to remove two lower linkage-to-
seat back panel attaching screws. (See Fig.
15-58).
3. Carefully return seat back to full up position;
then, place a support under seat back assembly
to support seat back in this position.
4. Remove two upper linkage-to-seat back panel
attaching screws. (See Fig. 15-58).
5. Remove nuts securing linkage support to floor
pan (See Fig. 15-56); then carefully remove
linkage assembly from seat back and floor pan.
6. To install, reverse removal procedure.
FOLDING SECOND SPLIT SEAT BACK
INNER LINKAGE ASSEMBLY
Removal and Installation
1. Remove left second seat cushion and place left
seat back in full up position. Place a support
under right side of left seat back to support
seat back in this position.
2. Place right seat back in partially down posi-
tion (resting on seat cushion).
3. Remove nuts securing inner linkage assembly
to floor pan (See Fig. 15-57).
L I N K A G E
TO - S E A T BACK SCREWS
1912
4. Remove inner linkage-to-seat back bolts from
both right and left seats (See Fig. 15-59); then
carefully disengage inner linkage from seat
backs and floor pan studs and remove linkage
assembly.
5. To install, reverse removal procedure. Make
sure bushings and spring washers are properly
installed prior to installing linkage attaching
bolts to both right and left seat back panels.
(See Fig. 15-59).
LUGGAGE COMPARTMENT LOCK CYLINDER
(OPTIONAL EQUIPMENT) -
15-16000 Two-Seat Styles
Removal and Installation
1. Open luggage compartment rear panel.
2. On underside of luggage compartment rear
panel remove catch retainer and catch from
lock cylinder case (Fig. 15-60); then turn lock
cylinder with key until cylinder can be removed
from case.
3. To install, reverse removal procedure.
LUGGAGE COMPARTMENT LOCK
(OPTIONAL EQUIPMENT)-
15-16000 Two-Seat Styles
Removal and Installation
1. Open luggage compartment rear panel.
2. On underside of luggage compartment rear
panel, remove catch retainer and catch (Fig.
15-60).
3. Remove lock cylinder case retainer screw and
retainer (Fig. 15-60); then, remove lock cylin-
der and case, gasket and escutcheon from panel
(Fig. 15-60).
LEFT SEAT BACK LINKAGE
-BUSHINGS
LINKAGE
BOLTS
SPRING WASHERS
_
" \ LINKAGE
RIGHT SEAT BACK LINKAGE
SUPPORT
1913
Fig. 15-58—Folding Second Seat Back Supports and
Linkage (Full Width Seats)
Fig. 15-59—Folding Second Seat Back Inner Linkage
and
Support
Advertisement
