Advertisement
11-4
HEADLINING
PINCHWELD
RETAINING
CLIP
MOLDING
2194
Fig. 11-4— Side Roof Rail Garnish Moldings
bow. In like manner, working forward, install
No. 2 and No. 1 listing wires. (View "D",
Fig. 11-1).
NOTE:
Listing wires may be adjusted up or
down by utilizing appropriate holes in side
roof rails.
Listing wires should rest tight
against roof panel after installation. (Views
"A" and "B" in Fig. 11-1).
5. Stretch and secure headlining at windshield and
back window or back body opening. Stretch and
PRONGED RETAINER
Fig. 11-5— Headlining Installation at Roof Extension
secure headlining at rear quarters and side
roof rails. Permanently attach material re-
moving draws and wrinkles and replace all
previously removed inside hardware and trim
assemblies.
HEADLINING-FLOCKED HEADLININGS
DESCRIPTION
The flocked headlining assembly consists of five
individual sections.
The headlining sections are secured in place by
retainers formed to the contour of the roof panel.
Plastic moldings are snapped over the retainers
and cover the retainers and edges of the headlining
sections. Windshield, back window and side roof
rail garnish moldings, also assist in holding the
headlining in place.
When necessary, the headlining sections may be
individually removed and replaced.
support assemblies and rear view mirror sup-
port. If removing rear section, remove back
window garnish moldings, side roof rail gar-
nish moldings and rear quarter trim assembly
to gain access to headlining at side roof rail
area. If center sections are removed, where
required, remove dome lamps, coat hooks,
coat hook spacers (if present) and shoulder
strap anchor plates and escutcheons.
3. With flat-bladed tool, carefully pry one end of
plastic molding from retainer and remove
(View "C", Fig. 11-6). Remove plastic mold-
ings from both retainers securing section of
headlining being removed.
REMOVAL (ONE OR MORE SECTIONS)
1. Place protective coverings over seat cushions
and backs.
2. Remove side roof rail moldings. If removing
front section of headlining, remove windshield
upper and side garnish moldings, sunshade
4. When removing individual sections, use flat-
bladed tool and carefully pry one edge of head-
lining section from retainer and remove from
body.
5. If removing headlining section at back window,
remove tacks or staples securing section at
back window opening.
Advertisement
