Advertisement
SEATS
15-51
\
INNER LINKAGE
TO SEAT BACK
PANEL SCREWS
REAR FLOOR FILLER
PANEL RETAINER
REAR FLOOR
FILLER PANEL
INNER LINKAGE TO
CUSHION FRAME SCREWS
Fig. 15-72 —Folding Second Seat Inner Linkage
2. Remove seat back trim assembly attaching
screws, (see Fig. 15-69).
3. Raise seat back; then, pull seat back trim as-
sembly upward to disengage wire loops at top
of seat back trim from slots in seat back
panel.
NOTE:
If seat back trim does not readily dis-
engage from seat back panel, fold rear floor
filler panel down and remove upper inboard
screw securing automat or carpet (Fig. 15-71).
Then remove seat back trim assembly.
4. To install seat back trim assembly, reverse
removal procedure.
FOLDING SECOND SEAT FRONT FLOOR
PAN LINKAGE-Right or Left Seat-"65" Styles
Removal and Installation
1. Place seat in an up position. Turn back floor
carpet sufficiently to gain access to front link-
age floor pan attaching nuts.
2. Mark location of front linkage support on floor
pan to facilitate installation in same position.
Support front of seat. Remove bolts securing
linkage to seat and nuts securing linkage to
floor pan studs (see Fig. 15-70); then, remove
front linkage.
3. To install, reverse removal procedure making
sure linkage support on floor pan is aligned
with previously made alignment mark.
FOLDING SECOND SEAT REAR FLOOR
PAN LINKAGE-Right or Left Seat-"65" Styles
Removal and Installation
1. Remove folding second seat assembly from
car as previously described and place on a
clean surface.
2. Remove screws securing rear floor pan link-
age to each side of seat cushion frame (Fig.
15-73); then, remove linkage assembly from
seat.
3. To install, reverse removal procedure. Inserts
in Figure 15-73 show relationship of linkage,
bushings and attaching screws.
FOLDING SECOND SEAT SIDE INNER
LINKAGE-Right or Left Seat-"65" Styles
Removal and Installation
1. Remove folding second seat assembly from car
as previously described and place on a clean
surface.
2. Remove floor pan rear linkage-to-seat inner
linkage attaching screws (Fig. 15-73).
3. Remove seat inner linkage-to-seat back panel
and seat cushion frame attaching screws (see
Fig. 15-72); then, disengage and remove side
linkage from seat.
4. To install, reverse removal procedure. Make
sure rear floor filler panel retainer is inserted
through slot in seat back panel prior to in-
stalling inner linkage-to-seat back panel at-
taching screws.
SPRING WASHERS
REAR LINKAGE
\ V v J i S ^ J *
pTO SEAT INNER
\Q&zZ^.
WASHER—y
^ A
f v
\ \ \
)
^
B U S H I N G
\ / ^
'
^ P P1N G
^ ^ t
WASHER
5 U t W
— ^
—
f-
REAR
"SEAT
^ S C R E W S
BUSHING
^
LINKAGE TO
OUTER SCREW
1217
Fig. 15-73 — Floor Pan Rear Linkage
Advertisement
