Advertisement
7-18
REAR QUARTER
Fig. 7-25-Rear Quarter Hardware - " A - 1 7 " Style
Rear Guide Adjusting
Studs and Nuts
Up-Stop Bolts
Front Guide Upper Adjusting
Studs and Nuts
Regulator Bolts
Front Guide
Lower Adjusting
Studs and Nuts
guide upper and lower attaching bolts (Fig. 7-
36). Disengage guide from roller on window
assembly and remove guide through access
hole.
2. Remove glass run channel inner and outer strip
assemblies (draft strips) as outlined in the
''Front and Rear Door" section of this man-
ual - see index. Remove lock pillar sealing
strip.
3. Remove front guide lower two adjusting stud
nuts and loosen upper two nuts (see Fig. 7-36).
4. Rotate rear edge of glass upward until regula-
tor lift arm roller is free of sash channel cam
and two front glass rollers are out of front
guide channels. Remove glass inboard of side
rail.
assembly and identifies the various components
and their assembly sequence.
ADJUSTMENTS-"X-37" Style
To perform any rear quarter window adjustments,
it is necessary to remove the rear quarter trim as-
sembly.
1. To adjust window "fore or aft", loosen front
and rear guide adjusting stud nuts, position
window and guides as required, and tighten
nuts.
2. To adjust window "in or out" at belt line,
loosen front guide upper adjusting stud nuts,
adjust studs in or out as required, and tighten
stud nuts.
in or out", loosen
3. To adjust top of window
front guide lower adjusting stud nuts, adjust
studs in or out as required, and tighten stud
nuts.
4. To relieve a "fore or aft" binding condition
between front and rear guides, loosen front
5.
NOTE:
If additional clearance is needed, the
side roof rail weatherstrip can be detached at
quarter window area.
To install, reverse removal procedure. Figure
7-37 is an exploded view of the quarter window
Fig. 7-26—Rear Quarter Hardware - " A - 6 7 " Styles
1. Rear Guide Adjusting
Studs and Nuts
2. Up-Stop Bolt
3- Front Guide Upper Adjusting
Studs and Nuts
4. Regulator Bolts
5. Front Guide
Lower Adjusting
Studs and Nuts
Advertisement
