Advertisement
ELECTRICAL
16-45
Fig. 1 6 - 7 3 - S i x - W a y " S t r a t o " Seat
1. Control Switch
2 . Motor
3. Motor Control Relay
4 . Harness Feed Connector
5. Rubber Coupler
6. Front Vertical Control
Cable (Yellow)
7. Rear Vertical Control
Cable (Blue)
8. Horizontal Control Cable
(Black)
9. Transmission and Solenoid
Assembly
10. Ground Wire
Fig. 1 6 - 7 4 - S i x - W a y Standard Bench Seat
1. Horizontal Control
Cable (Black)
2. Rear Vertical Control
Cable (Blue)
3. Ground Wire
4. Motor
5. Control Switch
6. Front Vertical Control
Cable (Yellow)
7. Motor Control Relay
8. Rubber Coupler
9. Harness Feed Connector
10. Transmission and Solenoid
Assembly
11. Front Vertical Control
Cable (Yellow)
12. Transmission End Plate
mechanical failure in the seat unit, the sole-
noid is defective.
Three-Way Jumper Wire for
Checking Seat Switch
To make jumper wire, obtain two pieces of #12
gauge wire, each 4 1/2" long, join one end of each
wire as shown in Figure 16-80. The joined end
can be inserted in the feed location in the switch
block; one of the remaining ends can be inserted
into one of the field locations in the switch block;
the other end can be inserted into one of the sole-
noid locations.
IMPORTANT:
To obtain a seat movement using
a 3-way jumper wire at the switch block, the
switch feed location, one of the motor field wire
locations and one of the solenoid locations must
be connected simultaneously.
On Bodies with Switch in Seat Side Panel:
1. To raise front edge of seat, place jumper in
locations, A, F and E.
2. To lower front edge of seat, place jumper in
locations A, C and E.
3. To raise rear edge of seat, place jumper in
locations A, F and D.
4. To lower rear edge of seat, place jumper in
locations A, C and D.
5. To move seat forward, place jumper in loca-
tions A-B and F.
6. To move seat rearward, place jumper in loca-
tions A-C and B.
On Bodies with Switch in Arm Rest:
1. To raise front edge of seat, place jumper in
locations A-C and E.
2. To lower front edge of seat, place jumper in
locations A-F and E.
3. To raise rear edge of seat, place jumper in
locations A-C and D.
4. To lower rear edge of seat, place jumper in
locations A-F and D.
5. To move seat forward place jumper in loca-
tions A-C and B.
6. To move seat rearward, place jumper in loca-
tions A-F and B.
Advertisement
