Advertisement
6-76
DOORS
FRONT DOOR WINDOW GLASS RUN
CHANNEL-"B-11-35-45 and 69" Styles
Removal and Installation
1. Remove door trim assembly and detach inner
panel water deflector.
2. Lower window to approximately half-down po-
sition and tie or tape window so that front
edge of window remains engaged in ventilator
division channel.
3. Remove glass run channel upper attaching bolt
(at belt) and lower adjusting stud nut (Fig.
6-101).
4. From outside door, insert a sharp pointed right
angle tool (reveal molding clip disengaging
tool J-21549 or equivalent) between outer edge
of glass run channel and door upper frame as
shown in Figure 6-102).
5. Beginning at front end of run channel, slide
tool rearward until a clip is contacted, then
engage point of tool under clip and carefully
pry inboard to release clip tangs from door
frame.
6. Repeat step 5 at each clip location until run
channel is completely disengaged from door
frame.
7. Remove glass run channel from door by care-
fully lowering upper end of channel down into
door (rearward of glass) while simultaneously
directing lower end (adjusting stud end) of
channel out through the rectangular (4" x 6")
access hole in lower center of door inner
panel.
8. To install, reverse removal procedure. Begin
installation above belt at door upper frame
upper rear corner.
NOTE:
Prior
to installation,
inspect
run
channel clips and saturated polyurethane foam
sealing strips in door upper frame (Fig. 6-
103). Reform distorted clips to insure adequate
retention.
Replace damaged sealing strips with Service
Part which is available in five foot lengths
(Part #4480378 or equivalent).
(Hi
SECTION
A-A
SECTION B-B jgf*
w
1
SATURATED
POLYURETHANE
SEALING STRIP
I
1595
Fig. 6-103 — Front Door Window Glass Run
Channel Sealing - " B & C "
Closed Styles
FRONT DOOR WINDOW GUIDE AND
GUIDE PLATE ASSEMBLY-AM "B-C"
Styles Except "B-l 1-35-45-57-69" Styles
Removal and Installation
1. Remove rear door trim assembly and inner
panel water deflector.
2. Operate window to approximately half-up posi-
tion and remove lower sash channel to guide
plate attaching screws ("1", Fig. 6-104).
3. Remove guide upper attaching bolt " 5 " and
guide to lower support bracket attaching bolt
"6" (Fig. 6-104).
4. Reaching through large forward access hole,
disengage guide plate from window lower sash
channel and remove guide and guide plate, as
an assembly, from door.
5. To install, reverse removal procedure. Align
guide for proper window alignment and opera-
tion as described under "Front Door Window
Adjustments".
FRONT DOOR WINDOW FRONT
GUIDE-26657 Style
Removal and Installation
1. Remove door trim assembly and inner panel
water deflector.
Advertisement
