Advertisement
6-114
DOORS
IMPORTANT:
The glass run channel must be
properly seated and conform to shape of door
upper frame to achieve proper glass operation.
REAR DOOR WINDOW FRONT OR
REAR GUIDE-"Z-39" Styles
Removal and Installation
1. Remove door trim pad and inner panel water
deflector.
2. Loosen front and rear up-travel stop attaching
screws.
Rotate stops so that the stop tabs
enter angled slots. Raise window as far as
possible.
Remove upper attaching screw and lower ad-
justing stud nut from guide being removed.
Lower guide to disengage it from sash channel
roller, then remove guide through large access
hole.
REMOTE CONTROL
BOLTS
Fig. 6-157 —Rear Door Hardware - " A " Styles Shown
5. To install, reverse removal procedure. Cycle
window several times to insure proper opera-
tion before installing water deflector and door
trim pad.
4. To install, reverse removal procedure.
REAR DOOR WINDOW REGULATOR
ASSEMBLY-"A-35-55-65 and 69"
Styles and "X-35 and 69" Styles
Removal and Installation
1. Raise door window, remove door trim pad and
detach inner panel water deflector.
Secure window in the full-up position by in-
stalling a twelve to fifteen inch piece of body
tape (2" or 2-1/2" in width) over window frame
and firmly pressing tape to both sides of glass.
This is necessary to positively hold glass in
the up position during removal of window
regulator.
3. Remove inner panel cam on "A" Body Styles.
4. Remove window regulator attaching bolts and
move regulator assembly rearward to disen-
gage lift arm rollers (and balance arm rollers
on "A" Styles) from window lower sash channel
cam and remove regulator through large ac-
cess hole (See Fig. 6-157).
REAR DOOR WINDOW REGULATOR-
MANUAL AND ELECTRIC-
All "B & C" Styles
Removal and Installation
1. Remove rear door trim assembly and inner
panel water deflector.
2. Remove lower sash channel cam attaching
screws (Fig. 6-158 for "closed" styles; "5",
Fig. 6-151 for "hardtop" styles). While sup-
porting glass, disengage cam from rollers on
regulator lift and balance arms and remove
cam.
3. Raise window and prop it in full-up position.
4. Remove inner panel cam attaching bolts (Fig.
6-158 for "closed" styles; "6", Fig. 6-151 for
"hardtop" styles).
5. On styles equipped with electric window regu-
lators, disconnect body wire harness from
window regulator at window regulator motor.
Advertisement
