Advertisement
REAR QUARTER
7-5
4. Lower window to full "down" position. Tighten
center guide lower attaching screw while forc-
ing lower portion of guide rearward.
NOTE:
Do not apply too much pressure when
forcing guide rearward as this tends to make
front edge of glass dig into front run channel.
3.
4.
On "X" styles, remove support to regulator
plate screws (Fig. 7-18). Raise window to full-
up and prop in that position.
On "A & B" styles, remove regulator to inner
panel screws and remove regulator through
large access hole (see Fig. 7-19).
REAR QUARTER W I N D O W REGULATOR
(MANUAL AND ELECTRIC)-
"A, B & X'
1
Closed Styles
Removal and Installation
5. On "X" styles, remove regulator to inner
panel screws (Fig. 7-18). Disengage roller on
regulator plate from window guide and remove
regulator through large access hole.
1. Remove rear quarter trim assembly and inner
panel water deflector. On electric styles, dis-
connect feed wire from regulator motor.
2. On "A & B" styles, disengage clip retainer
from pivot pin on window lower sash channel
(see Fig. 7-16 and 7-17). Raise window to full-
up and prop in that position.
6. To install, reverse removal procedure.
NOTE:
The procedure for removing electric
motor
from
regulator
is described under
"Door and Quarter Window Regulator Electric
Motor Assembly" in the Door section of this
manual.
Fig. 7-6-Rear Quarter Hardware - " A - 6 7 " Styles
1. Sash Channel Cam
2. Rear Guide
3. Front Guide
4. Window Regulator (Manual)
5. Up-Stop
6. Window Regulator
(Electric)
7. Rear Guide Lower Stop
Advertisement
