Advertisement
FRONT END
5-5
SHROUD AIR OUTLET DUCT DOOR
CONTROL CABLE
Removal and Installation-("F-X-Z" Styles)
1. Remove outlet grille and outlet duct assembly.
2. Disconnect cable on door.
3. Remove retainer securing control assembly to
finishing panel (Fig. 5-5) and remove control
assembly.
4. To install, reverse removal procedure.
DESCRIPTION-
26657 and "E" Body Styles
The "26657" and "E" body styles incorporate the
same air inlet principles as the other styles. The
exhausting air on the 26657 style is routed out
under the rear seat, up back of the rear seat back,
and out through pressure relief valves. Air passes
through the pressure relief valves into the plenum
chamber and out through the grille in the body lock
pillar.
The exhausting air on the Buick "E" body is routed
out through pressure relief valves located in the
rear compartment shelf and rear plenum chamber.
Air passes through a grille in the rear compart-
ment shelf trim panel down through the pressure
relief valve and out of the rear plenum chamber
grille.
The exhausting air on the Oldsmobile " E " body is
routed out under the rear seat, up back of the rear
seat back and out through pressure relief valves
(Fig. 5-7). Air passes through the pressure relief
valves into the plenum chamber and out through
the plenum chamber grille.
The exhausting air on the Cadillac "E". body is
routed out under the rear seat, up back of the rear
seat back and out through pressure relief valves.
Air passes through the pressure relief valves into
the plenum chamber and out through the grilles in
the quarter panel and the body lock pillar.
Water entering the rear plenum chamber is drained
out through attached hoses that extend through the
floor pan or rear quarter filler panel.
INSTRUMENT PANEL
INSTRUMENT PANEL COMPARTMENT
DOOR-AM Except "E" Bodies and
" C " Cadillac Bodies
5-9, 5-10, 5-11 and 5-12), lift door, rotate counter-
clockwise to remove stop from opening in panel.
To install, reverse removal procedure.
Removal and Installation
The instrument compartment door hinges and stops
are an integral part of the door or attached by
screws. The hinges and door assemblies are at-
tached to the instrument panel by screws. To re-
move the door assemblies, remove attaching
screws securing hinge to instrument panel (Figs.
STRIKER
• — - ^ ^ Z
Ho
HINGE SC REWS
^^
LOCK CYLINDER
'
—
•
—
—
^
.
—
—
•
—
f
LO(
&•
-S
/STOP
1
:K SCREW
HOUSING
vS
1192
Fig. 5-9—Instrument Panel Compartment Door
Fig. 5-10—Instrument Panel Compartment Door
Advertisement
