Advertisement
SEATS
15-9
2
to
\
7
2437
1. Adjuster to Seat Frame
Attaching Bolts
2. Motor Assembly
3. Transmission Assembly
Fig. 15-6 —Front Seat Assembly - Four-Way Tilt - " A " Styles
4. Track Cover Supports
5. Motor and Transmission
Support Attaching
Screws
6. Vertical Cable (Yellow)
7. Horizontal Cable (Black)
previously described and place upside down on
a clean protected surface.
3. Detach vertical gearnut drive cable from other
adjuster.
4. Using a clutch type screwdriver or other suit-
able tool, remove shoulder screws securing
linkage to vertical gearnut being replaced (Fig.
15-8).
5. If right adjuster gearnut is being replaced, at
front of jackscrew, remove double nut that acts
as a jackscrew "down" stop.
6. Using a portable power source to energize
the motor, actuate vertical gearnut until gear-
nut is disengaged from jackscrew.
NOTE: It may be necessary to manually raise
or lower upper rear portion of adjuster to gain
clearance for removal of gearnut.
8. To install, reverse removal procedure.
NOTE: Check operation of seat adjusters and
make sure adjusters are "in phase"..See step
6 under "Front Seat Assembly - Removal and
Installation".
HORIZONTAL ACTUATOR-"A" Body
Removal and Installation
1. Remove adjuster vertical gearnut as previ-
ously described.
2. Disconnect d r i v e c a b l e from horizontal
actuator.
3. Remove screws securing horizontal actuator
assembly to adjuster lower track; then remove
actuator from adjuster assembly (Fig. 15-8).
7. Disconnect drive cable from gearnut.
4. To install, reverse removal procedure.
Advertisement
