Advertisement
TAIL GATE
9-7
PILLAR CONTACT PLATE
BODY WIRING
(FOR GROUND)
TAIL GATE CONTACT PLATE
VIEW IN DIRECTION OF ARROW
2055
Fig. 9-11 - " X " Body Tail Gate Jamb Switch
Installation
1. Lubricate the motor drive gear and regulator
sector teeth with Lubriplate or its equivalent.
2. With tail gate in an open position, install regu-
lator motor to regulator. Make sure the motor
pinion gear teeth mesh properly with the sec-
tor gear teeth before installing the three motor
attaching screws.
3. Tighten regulator attaching screws and remove
screw
locking
sector
gears
into a fixed
position.
4. Connect wire harness to motor and cycle tail
gate window prior to installation of inner panel
DRILL 1/8 DIA. HOLE
LOOSEN 2 BOLTS
REMOVE 3 BOLTS
1622
access
panel.
hole cover, water deflector and cover
Fig. 9-12 —Tail Gate Regulator Motor Assembly
TAIL GATE WINDOW REGULATOR
OUTSIDE HANDLE-MANUAL OR
ELECTRIC
Removal and Installation
1. Lower tail gate and remove inner panel cover
and water deflector.
2. Position tail gate window so that outside handle
(or key switch) attaching nuts are accessible
through gate inner panel and window regulator
access holes. (See Fig. 9-13).
3. Remove nuts securing handle (or key switch)
to tail gate and remove handle and sealing
gasket. (See Fig. 9-14).
NOTE:
On electrical styles, disconnect wire
harness from connector on escutcheon (key
switch).
4. To install, reverse removal procedure.
TAIL GATE WINDOW
LOWER GLASS RUN CHANNELS
Removal and Installation
1. Remove tail gate window.
2. Remove bolts securing run channel(s) to tail
gate. (See Fig. 9-5).
Advertisement
