Advertisement
6-106
DOORS
LOWER SASH CHANNEL
TO GUIDE PLATE I l l g J )
S T U D NUT^llfll^lBOl
r n"i it i " ""l " i ™ f f " " 1 1 J j
I S T O P B O I J S J H H M
Fig. 6-141 —Rear Door Window Removal -
68069-68169 Styles
6. To install, reverse removal procedure. Adjust
window for proper operation and alignment as
described under "Rear Door Window and/or
Ventilator Adjustments''.
REAR DOOR VENTILATOR REGULATOR-
68069 and 68169 Styles
Removal and Installation
1. Remove door trim assembly and inner panel
water deflector. Operate door glass to full-up
position.
2. Disconnect ventilator regulator wire harness
connector at regulator motor.
VENTILATOR FRAME BOLTS'
VENTILATOR*^
- SHAFT BOLT
VENTILATO
LATOR
VENTILATOR LOWER
ADJUSTING
VENTILATOR DIVISIO
CHANNEL ADJUSTING
STUD AND NUT
Fig. 6-142 —Rear Door Window Removal -
68069-68169 Styles
Fig. 6-143 —Rear Door Ventilator Attachments -
68069-68169 Styles
3. Remove ventilator "T- shaft" to regulator at-
taching bolt (Fig. 6-143).
4. Remove ventilator regulator to ventilator
frame attaching bolts (Fig. 6-143).
5. Disengage ventilator regulator from ventilator
"T-shaft" and remove regulator through ac-
cess hole.
6. To install, reverse removal procedure.
REAR DOOR VENTILATOR ASSEMBLY-
68069 and 68169 Styles
Removal and Installation
1. Remove rear door ventilator regulator as pre-
viously described.
2. Remove ventilator lower frame and ventilator
division channel lower adjusting stud nuts (Fig.
6-143).
3. Remove ventilator lower frame attaching bolts
(Fig. 6-143).
4. Lift ventilator assembly up approximately 3"
and remove ventilator lower frame adjusting
stud through access hole.
5. Lift ventilator upward and remove from door.
Twist ventilator 90° to remove division channel
lower adjusting stud at belt.
Advertisement
