Advertisement
15-44
SEATS
LINKAGE UPPER SCREWS
1910
Fig. 15-56—Folding Second Seat Back Supports
(Full Width Seat)
NOTE:
Do not remove screws securing rear
floor filler panel hinge to second seat back
panel.
3. Pull lower edge of seat back trim slightly
forward; then lift trim assembly upward to dis-
engage trim border wire from tabs on upper
portion of panel. Remove trim assembly from
body and place on a clean protected surface.
4. To install, reverse removal procedure. Make
sure seat back trim border wire is engaged
with panel tabs at upper portion of seat back
panel prior to installing seat back trim attach-
ing screws.
FOLDING SECOND SEAT BACK TRIM,
PANEL AND LINKAGE ASSEMBLY
(FULL WIDTH OR SPLIT SEAT)-All Styles
Removal and Installation
1. Raise folding second seat back and remove
second seat cushion.
2. On underside of folding second seat back re-
move screws securing rear floor filler panel
hinge to seat back panel.
NOTE:
Do not remove screws securing seat
back trim assembly to seat back panel.
3. Mark position of folding second seat back
linkage supports on floor pan. Remove nuts
from both sides of seat back securing linkage
supports to floor pan (See Figure 15-56), full
width seat (Fig. 15-57) for split seat.
Lift seat back assembly with attached linkage
from body and place on a clean protected
surface.
4. To remove linkage from folding second seat
back remove linkage-to-seat back panel attach-
ing bolts and remove linkage - See (Fig. 15-58
for full width seat) (Fig. 15-59 for split seat).
5. To install, reverse removal procedure. If
linkage was removed from split seat back,
make sure bushings and spring washers are
properly installed prior to installing linkage
attaching bolts. (See Fig. 15-59).
FOLDING SECOND SEAT BACK LINKAGE
ASSEMBLY (FULL WIDTH SEAT-Right or Left
Side Split Seat—Outer Linkage Only)
If both right and left linkage assemblies are to be
removed on full width second seat remove second
seat back trim, panel and linkage assembly and
remove linkage from seat back panel as described
under "Folding Second Seat Back Trim, Panel and
Linkage Assembly - Removal and Installation".
If one linkage assembly (right or left side) is to be
removed proceed as follows:
SUPPORT NUTS
LEFT SEAT BACK
INNER LINKAGE
/
INNER SUPPORT
RIGHT SEAT BACK
INNER L I N K A G E ^
1911
Fig. 15-57—Folding Second Seat Back Supports and
Linkages (Split Seat)
Advertisement
