Advertisement
DOOR, QUARTER AND SHELF TRIM
14-15
rear body lock pillar and remove assembly
from body.
NOTE:
If trim assembly incorporates electric
window switch, disconnect wire harness con-
nector from window switch.
The finishing molding retainer (Fig. 14-19,
View "C") is retained by screws and can be
removed at this point, where required.
9. To install, reverse removal procedure. Prior
to installation of pinchweld finishing strip,
recement forward edge of trim to pinchweld
flange (Fig. 14-19, View "B").
REAR QUARTER TRIM ASSEMBLY-
AM " F " Bodies
Removal and Installation
NOTE:
On styles equipped with shoulder straps,
the shoulder strap buckle retainer on quarter
trim must be removed.
1. On styles equipped with arm rests proceed as
follows:
a. Remove quarter window regulator handle.
b. Lower folding rear seat back.
c. Remove screws securing seat back panel to
quarter inner panel filler panel on "37"
styles and screws securing folding top com-
partment side trim panel on "67" styles
(Fig. 14-26 and 14-27).
d. Remove screws securing arm rest assem-
bly (Fig. 14-26 and 14-27).
e. Remove body lock pillar pinchweld finishing
lace.
f. Carefully detach front cemented edge of
trim material from body lock pillar pinch-
weld flange.
g. Carefully bend or bow trim pad inboard
sufficiently to disengage upper edge of trim
from under finishing molding retainer and
remove trim pad, arm rest and folding top
side compartment panel or rear seat back
to quarter inner panel filler panel as an
assembly. On styles equipped with elec-
trical devices, disconnect electrical leads.
NOTE:
As a bench operation the arm rest
and/or filler panel or folding top compart-
ment side panel can be removed by remov-
ing screws from the reverse side.
2. On styles
without arm rests, proceed as
follows:
a. Remove
r e a r
seat b a c k and cushion
assembly.
b. Remove quarter window inside regulator
handle.
c. Remove body lock pillar finishing lace.
d. Carefully detach front cemented edge of
trim from body lock pillar pinchweld flange.
e. Carefully bend or bow trim pad inboard suf-
ficiently to disengage upper edge of trim
from under finishing molding retainer and
remove trim pad.
3. To install, reverse removal procedure. Prior
to installation of pinchweld finishing lace, re-
cement forward edge of trim to pinchweld
flange.
REAR QUARTER T R I M -
AM "E" Bodies
Removal and Installation
1. Remove rear seat back and cushion assemblies
as described under "Rear Seats".
2. Remove quarter window regulator handle, and
shoulder strap buckle retainer if so equipped.
3. Remove seat back to quarter inner panel filler
panel on "39487" style only (Fig. 14-28).
4. Remove screw securing compartment finishing
side molding to quarter trim (Cadillac Style
only, Fig. 14-30).
5. Remove arm rest attaching screws (Fig. 14-28,
14-29 and 14-30). On Oldsmobile and Buick
styles only, carefully remove arm rest from
quarter trim and detach all electrical equip-
ment present.
6. Remove quarter trim attaching screws (Fig.
14-28, 14-29 and 14-30).
NOTE:
On Cadillac styles it is necessary to
open quarter window to gain access to attach-
ing screw from outside of body at beltline
(Fig. 14-30).
7. On Buick and Oldsmobile only, pry trim as-
sembly retaining nails from tacking strip along
body lock pillar using trim panel removing
tool (J-6335) (Fig. 14-28 and 14-29).
Advertisement
