Advertisement
6-78
DOORS
Fig. 6-105 —Front Door Hardware - 26657 Styles
Inner Panel Cam
Attaching Bolts
Window Regulator
Attaching Bolts
Window Front Upper
Stop
4. Front Guide Upper
Support Bracket
Attaching Bolts
5. Front Guide Wedge Strap
Adjusting Stud and Nut
Front Guide Lower
Attaching Stud and Nut
Window Rear Upper Stop
(On Window)
Rear Guide Upper Attaching
Bolts
9. Rear Guide Lower Attaching
Bolt
10. Rear Guide Wedge
Strap Adjusting
Stud and Nut
3. Remove rear guide upper and lower attaching
bolt " 8 " and "9".
4. Remove adjusting stud nut "10" and turn stud
6 to 8 full turns (clockwise) to eliminate wedge
strap to window interference.
5. Pull guide down and forward to disengage from
window rear roller and remove guide from
door.
6. To install, reverse removal procedure.
DOOR WEDGE PLATES-"67" Styles
Door wedge plates are used on convertible styles to
give additional support to the door when it is in the
closed position. One plate is installed to the body
lock pillar and the other to the door lock pillar
(Fig. 6-106). The plates should contact each other
to the extent of a 1/32" interference when the door
is closed. Body side wedge plate shims are avail-
able as a service part so that this interference can
be obtained.
VACUUM DOOR LOCK SYSTEM
The vacuum door lock system is operated by selec-
tor valves located in the front door trim assem-
blies. When either valve is actuated upward, all
Advertisement
