Advertisement
SEATS
15-17
SUPPORT PAD
SUPPORT
SOLENOIDS &
COVER PLATE
HARNESS
CONNECTOR
DRIVING GEAR
THRUST WASHER -J
GEAR HOUSING
RUBBER
COUPLING
1372
Fig. 15-15 —Six-Way Seat Adjuster Transmission - "B & C " Style
DISASSEMBLY AND ASSEMBLY
OF TRANSMISSION
1. Remove front seat adjuster transmission from
seat assembly.
2. Remove screws securing gear housing to the
solenoid housing; then, carefully separate
housings and remove component parts of trans-
mission assembly (Fig. 15-15).
3. To assemble transmission, reverse removal
procedure.
IMPORTANT:
Prior to or during installation,
lubricate frictional surfaces of driving gear,
thrust washer, large gears, dog washers, gear
shafts and solenoid plungers with "Lubriplate"
(630AAW) or equivalent.
FRONT SEAT BACK
SEAT BACK ASSEMBLY-Four Door Style with
Standard Full Width Seat
Removal and Installation
1. Remove front seat assembly from body and
2.
place it upside down on a clean protected sur-
face. Remove seat side panels, where present.
Remove hog rings securing lower edge of seat
back trim to seat cushion springs.
3. On "A-X & Z " body full width front seats,
raise lower edge of seat back trim, detach
cardboard breakover foundation and bend out
tabs on seat back frame securing seat cushion
springs (Fig. 15-16). Disengage springs from
tabs.
4. At each end of seat, remove hog rings securing
lower edge of seat back trim to seat bottom
frame. Raise or turn back seat back trim to
expose bolts securing seat back frame to seat
cushion frame (Fig. 15-17). Where seat back
lighter or courtesy light is present disconnect
wire from seat cushion frame.
5. Place seat assembly in upright position. Then
with a helper, holding seat back assembly, re-
move seat back attaching bolts on each side of
seat and remove seat back assembly.
6. To install seat back assembly, reverse re-
moval procedure.
Advertisement
