Advertisement
7-24
REAR QUARTER
ROLLER
ROLLER
SASH CHANNEL CAM
WASHERS
1 2 6 9
Fig. 7-39—Rear Quarter Window Assembly -
" Z - 3 7 " Styles
REAR QUARTER WINDOW REGULATOR
ASSEMBLY (MANUAL OR ELECTRIC) -
"A, E, F, X & Z " Hardtop and
Convertible Styles
Removal and Installation
1. Remove rear quarter trim assembly and inner
panel access hole cover (or water deflector).
On electric styles, disconnect feed wire from
regulator or "in-line" connector.
2. On "E-87" styles, remove rear quarter win-
dow. On "A, X & Z-37" styles, prop window in
a full-up position.
3. On "Z-37" styles, remove rear quarter win-
dow rear guide assembly.
4. On "E-47" styles, disconnect regulator lift
arm from quarter window as described in
"Rear Quarter Window Assembly" (see index).
5. Remove regulator to quarter inner panel at-
taching bolts, disengage lift arm roller from
sash channel cam and remove regulator.
NOTE:
If necessary, loosen upper attach-
ing points of front guide to gain additional
clearance.
SECTION A-A
(STOP)
SECTION C-C & F-F
(REAR G U I D E )
SECTION D-D
( F R O N T GUIDE UPPER
i
SECTION E-E
**
(FRONT GUIDE LOWER)
2449
Fig. 7-40—Rear Quarter Window Adjustments - " Z - 3 7 " Styles (Arrows Indicate Adjustment Direction Available)
Advertisement
