Advertisement
DOORS
6-55
LsASH CHANNEL CAM
SASH CHANNEL EXTENSION
CHEVROLET
.SASH CHANNEL CAMS
SLOT FOR FRONT UP-STOP
BUICK OLDSMOBILE PONTIAC
2084
Fig. 6-76-Front Door Window Assembly - "A-17 and 67" Style
Removal and Installation
1. Raise door window to a position of almost
fully closed (see Fig. 6-74).
2. Remove door trim pad and detach inner panel
water deflector sufficiently to gain access to
guide plate attaching bolts.
3. Remove two bolts securing guide plate to glass
lower sash channel and remove guide plate (see
Fig. 6-74).
4. To install, reverse removal procedure. Fore
and aft adjustment of the guide plate is pro-
vided by usage of elongated attaching holes.
NOTE:
Figure 6-74 is for "17 and 67" Styles.
Refer to Figure 6-79 for "39" Styles.
FRONT DOOR WINDOW UP-TRAVEL
STOPS-"A-E-F-X & Z" Hard Top and
Convertible Styles
On "A-Z & X" Body Styles, the rear up-travel stop
is attached (single bolt) to glass sash channel and
contacts a welded-on support (flange) on door inner
panel. The front up-travel stop is attached (single
bolt) to an extension in the glass sash channel and
contacts ventilator stationary stop (finger). Both
up-stops are adjustable up or down.
On "E" Body Styles, the front door window is
equipped with two up-stops, one front and one rear.
Both stops are attached to the glass lower sash
channel with single bolts that are accessible
through the door inner panel (see Fig. 6-75).
The "F" Body uses two up-travel stops. Both are
equipped with slots, allowing up or down adjust-
ment. When engaged, the front up-stop contacts an
extension (finger) of the ventilator division channel
and the rear up-stop contacts an extension (finger)
of the window rear guide.
Advertisement
