Advertisement
6-62
DOORS
2. Fore or aft and in or out adjustment at rear
edge of glass is provided by window rear guide
assembly. To gain fore or aft adjustment,
loosen rear guide to inner panel attaching
bolts, shift guide as required and retighten
bolts (see Fig. 6-83). For in or out adjustment,
loosen rear guide to guide plate attaching
bolts, shift guide as required and retighten
bolts (see Fig. 6-84).
NOTE: Adjustments 1 and 2 must be coordi-
nated to provide a properly operating front
door window assembly.
3. The door window inner panel cam is adjustable
at the forward attachment to correct a rotated
(cocked) door window.
4. The front and rear up-travel stops are adjust-
able up or down and can be used in controlling
glass height in the fully raised position.
FRONT DOOR WINDOW ASSEMBLY-
"X-37" Styles
The front door window glass is a solid tempered
safety plage glass. The glass fits into a lower sash
GUIDE TO
PANEL BOLTS
REAR GUIDE TO
PLATE B
REAR.UP TRAVEL
STOP BOLT
FRONT - UP TRAVEL i
STOP BOLT ( HIDDEN f
WINDOW REGULATOR
BOLTS — ^
y
* |
T W l N N E R PANEL
CAM BOLTS
Fig. 6-84 —Door Window Rear Guide Attachment -
" F " Styles
Fig. 6-85—Front Door Window Hardware
Attachments - " X - 3 7 " Styles
channel assembly which incorporates a welded-on
lower sash channel cam. With this type of design
the door glass, lower sash channel and channel cam
are removed from the door as a unit.
CAUTION: Care should be exercised to make
certain glass does not strike body metal during
installation or removal procedure as edge chips
can cause solid tempered safety plate glass to
shatter. DO NOT attempt to grind glass.
Removal and Installation
1. Remove door trim assembly and detach inner
panel water deflector.
2. Lower door window and remove front and rear
up-travel stops (see Fig. 6-85).
3. Remove front door ventilator casting and ven-
tilator assembly.
4. Remove window down-travel stop.
5. Lower window to full down position.
6. Slide window forward, while tilting front edge
upward, to disengage regulator lift arm from
lower sash channel cam and remove window
from door.
7. To install, reverse removal procedure. After
installation of window assembly, lubricate en-
tire length of lower sash channel cam and inner
panel cam with Lubriplate or equivalent.
Advertisement
