Advertisement
4-18
STATIONARY GLASS
15. Inspect installation for proper seal between
new caulking material and original material.
If a gap is encountered, apply sufficient caulk-
ing material to fill the void. On inside of body
run a flat stick around the pinchweld flanges to
push excess caulking material back into open-
ing between glass and flanges. Remove any
excess squeeze-out of material.
16. Watertest installation immediately using cold
water spray.
17. Remove masking tape from inside of glass.
18. Install reveal moldings, inside garnish mold-
ings and previously removed parts.
Advertisement
