Advertisement
6-50
DOORS
Fig. 6-67 —Front Door Hardware - " B - C " Hardtop and Convertible Styles
Inner Panel Cam
Attaching Bolts
Door Lock Remote Control
Attaching Bolts
3. Window Regulator
Attaching Bolts
4. Door Lock Screws
5. Ventilator T-Shaft to
Regulator Screw
Ventilator Regulator
8.
Attaching Screws
Ventilator Division Channel
9.
Lower Adjusting Stud and
Nut
10.
Ventilator Lower Frame
Adjusting Stud and Nut
Ventilator Frame to
Outer Panel Attaching Bolts
Door Window Front Upper Stop
vent can be adjusted in or out in relation to the side
roof rail.
To reposition the ventilator assembly up or down or
fore or aft, it is necessary to have the vent com-
pletely loose at all attaching locations, including
the ventilator regulator attaching screws (Fig. 6-
67).
To adjust the top of the ventilator in or out, loosen
only the adjusting stud nuts ("7" and "8", Fig. 6-
67) and adjust the studs in or out as required. It is
not necessary to loosen the vent to outer panel
bolts ("9", Fig. 6-67).
Ventilator Assembly and Disassembly
The "hardtop'' style ventilator permits more dis-
assembly than does the "closed" style vent. The
parts that can be removed and replaced are as
follows: division channel strip assembly, division
channel and vent lower frame, ventilator casting,
ventilator window assembly, ventilator weather-
strip (on casting), ventilator rear weatherstrip (on
casting), ventilator rear weatherstrip (on division
channel).
As shown in Figure 6-68, it is necessary to remove
the vent from the door to gain access to the vent
casting to vent frame screws.
Advertisement
