Advertisement
6-46
DOORS
VENT TO UPPER FRAME SCREWS
VENTTO DOOR
OUTER PANEL SCREW
VENTDIVISION CHANNEL
ADJUSTING STUD & NUT
VIEW A
VIEWB
VIEWC
2408
Fig. 6-61 —Front Door Ventilator Removal
3. On " F " Body Styles, remove door window
lower sash channel cam and lower glass to
bottom of door - see index.
4. Remove ventilator division channel lower ad-
justing stud nut and ventilator to door inner
panel attaching screw(s) (See Fig. 6-63). Turn
stud as far as possible out of contact with door
inner panel.
5. Remove ventilator frame to door hinge pillar
panel attaching screw. On "F" Body Styles, it
may be necessary to loosen top of door
weatherstrip to gain access to this screw (see
Fig. 6-64).
6. On all "A" Body Styles (except "A-39"), re-
move door window lower stop and completely
lower window. Lower door window on all other
styles.
7. On "X" Body Styles, remove front door ven-
tilator casting.
8. On "A", "F" & "Z" Body Styles, on door
hinge pillar, remove ventilator frame lower
attaching bolt, ventilator front frame attaching
screw(s) and ventilator frame lower adjusting
stud nut (see Fig. 6-63).
On "Z" Body Styles, loosen rear glass run
channel upper attaching screw and remove run
channel lower adjusting stud nut. Move door
glass as far rearward as possible.
Push ventilator lower adjusting stud free of
inner panel and rotate top edge of ventilator
rearward until front frame clears hinge pillar
(see Fig. 6-63).
11. On "A, X & Z" Body Styles, turn ventilator 90
degrees, as shown in Figure 6-63, and remove
assembly from body.
12. On " F " Body Styles, lift ventilator assembly
up; rock rearward slightly to clear front frame
from door hinge pillar and remove ventilator
from door.
9.
10.
Advertisement
