Advertisement
6-70
DOORS
1. Window Rear Guide
Bolts
2. Lower Sash Channel Cam
Attaching Screws
Fig. 6-94 —Front Door Hardware - " F " Styles
3. Inner Panel Cam
Bolts
4. Regulator Bolts
5. Remote Control Bolts
6. Ventilator Division Channel
Lower Stud and Nut
7. Ventilator to Door Inner
Panel Screw
proper glass to side roof rail weatherstrip
contact (Fig. 6-90).
c. Adjust stop " 1 1 " against sector gear (press
stop forward) and tighten stop bolt.
FRONT DOOR WINDOW REGULATOR
ASSEMBLY-Manual & Electric-
All "A-E-F-X & Z" Body Styles
Removal and Installation
1. Remove door trim assembly and detach inner
panel water deflector.
2. On two-door styles, remove inner panel cam.
3. On closed styles, raise door window. Secure
window in full up position by installing a twelve
to fifteen inch piece of body tape (2" or 2-1/2"
in width) over window frame and firmly pres-
sing tape to both sides of glass. This is nec-
essary to positively hold glass in the up
position d u r i n g
removal of the window
regulator.
4. On "A", "E" & "X" body hard-top and con-
vertible styles, prop door window in a full-up
position. On " F " body styles, prop window in
a full-up position on manual styles and remove
door window and ventilator assemblies on elec-
tric styles. Remove door window and ventilator
assemblies on all " Z " body styles.
NOTE:
On styles so equipped, remove door
window lower sash channel cam.
Advertisement
