Advertisement
13-24
FOLDING TOP
TACKING BACK CURTAIN
TO REAR BOW
Fig. 13-56 — Back Curtain Installed
11. Install rear trim stick with attached back
curtain assembly into body.
NOTE: Make sure that all trim stick bolts are
driven completely in to represent finished
condition.
12. Working from body center progressively out-
board to right and left sides, tack back curtain
to rear bow. Make sure all fullness has been
drawn from curtain material (Fig. 13-56). Any
excess material at rear bow, may be carefully
trimmed.
13. Check contour of back curtain assembly to
rear roof bow and at pinchweld molding.
14. Where required, place reference chalk mark
on outer surface of back curtain along pinch-
weld finishing molding. Re-adjust back curtain
assembly as required (Fig. 13-57).
BACK CURTAIN ASSEMBLY
15.
16.
CHALK
1532
Fig. 13-57-Marking Back Curtain
On "B, C & A" Styles, tack nylon webbing to
rear roof bow. Outboard edge of webbing
should be installed even with outboard edge of
side roof rail pad. Fold excess webbing rear
ward and tack to rear bow. Remove excess by
trimming webbing just forward of rear rolled
edge of rear roof bow.
CAUTION: Do not cut side stay pad material.
Detach rear trim stick with attached back cur-
tain assembly from body and install top trim
cover assembly.
NOTE:
Extra care in positioning new curtain
at same location on trim stick as old curtain
and aligning of trim stick attaching bolt holes
in top material with holes in trim stick will
allow re-installation of top material to its
original position with a minimum of refitting.
17. Install all previously removed t r i m and
hardware.
DESCRIPTION
FOLDING TOP SILENCER ASSEMBLY
Cadillac Styles
Removal of Silencer Assembly
The Silencer Assembly consists of a piece of
deadener material sewn to a lining type material
which is serviced as a complete kit. The Silencer
Assembly is installed in such a manner as to cover
the area between the front roof rail and front roof
bow, and from the right side stay pad to the left
side stay pad.
1. Lower top to stacked position.
2. Remove front roof r a i l front and r e a r
weatherstrips.
3. Remove side rail front weatherstrips.
Advertisement
