Advertisement
DOORS
6-107
VENTILATOR DIVISION
PILLAR GLASS RUN CHANNEL
DIVISION PILLAR
TO
VENTILATOR
UPPER FRAME
SCREW
VENTILATOR
DIVISION
PILLAR WEATHERSTRIP
BEND - OVER TABS
DIVISION PILLAR
TO
STATIONARY
FRAME SCREWS
VENTILATOR
WEATHERSTRIP
Fig. 6-144 —Rear Door Ventilator Assembly -
68069-68169 Styles
6. To install, reverse removal procedures. Ad-
just ventilator for proper operation and align-
ment as described under "Rear Door Window
and/or Ventilator Adjustments".
Ventilator Disassembly
1. Remove ventilator assembly from door as
previously described.
2. Remove ventilator division pillar glass run
channel strip assembly by disengaging lower
end and pulling strip upward (Fig. 6-144).
3. Remove division pillar to ventilator stationary
frame attaching screws (Fig. 6-144).
4. Remove division pillar to ventilator upper
frame (and rubber bumper) attaching screw
(Fig. 6-144) and separate ventilator frame and
division channel.
5. Align bosses on ventilator "T-shaft" with slots
in ventilator lower frame. Using hand pressure
only, force ventilator downward to disengage
ventilator upper pivot from ventilator casting.
6. S t r a i g h t e n
division
p i l l a r
weatherstrip
bend-over tabs (Fig. 6-144), and r e m o v e
weatherstrip.
7. Pull ventilator weatherstrip from front frame.
Three clips retain it down front edge and it
FRONT
GUIDE
SUPPORT
BRACKET
VIEW
IN CIRCLE A
BOLT
Fig. 6-145 — Front Guide to Support Bracket
Attachment - 68069-68169 Styles
may be necessary to pry between weatherstrip
and frame at these locations.
8. To assemble, reverse removal procedure.
NOTE:
The above procedure covers complete
disassembly of the ventilator, which in most
cases, will not be required. When servicing a
ventilator assembly, select only those steps
necessary.
REAR DOOR WINDOW AND/OR
VENTILATOR ADJUSTMENTS-
68069 and 68169 Styles
1. To adjust door window or ventilator assembly
in-or-out in relation to side roof rail, adjust-
ment is provided at the following attachments:
a. Door window front guide to support assem-
bly attaching bolt (Fig. 6-145). Access to
this bolt can be gained through large access
hole.
b. Front guide upper attaching bolt (Fig. 6-
142).
c. Ventilator division channel and ventilator
frame lower adjusting studs (Fig. 6-143).
These attachments can be adjusted in combination
or individually to achieve desired adjustment. When
adjusting ventilator adjusting studs, loosen venti-
lator lower frame attaching bolts prior to adjust-
ment, then, retighten after adjustment.
2. To adjust door window fore-or-aft,
loosen
guide plate to lower sash channel attaching
Advertisement
