Advertisement
7-12
REAR QUARTER
Fig. 7-13-Rear Quarter Hardware - " X - l l " Style
1. Front Glass Run Channel
2. Rear Glass Run Channel
3. Window Regulator
4. Window Guide
5. Window Support to
Regulator Plate
2. With quarter window partially lowered, remove
nuts securing regulator lift arm cam to regu-
lator lift arm and remove cam.
NOTE:
Lift arm must be pushed inboard
slightly to remove cam.
3. While supporting glass, remove quarter window
front guide attaching bolts and lower guide to
bottom of rear quarter.
4. Remove quarter window inboard of roof panel.
5. To install, reverse removal procedure. Fig.
7-29 is an exploded view of the quarter window
assembly and identifies the various components
and their assembly sequence.
ADJUSTMENTS-"E-87" Styles
Fore and aft alignment is determined by positioning
front guide. Adjusting rear guide will provide par-
allel condition of quarter window to door for con-
stant seal. In or out alignment is determined by
upper two adjusting studs and nuts at front guide.
The adjustable up-stop will provide up or down
alignment and partially fore and aft alignments by
controlling window travel.
and rear guide adjusting stud nuts, position
window and guides as required, and tighten
nuts.
2. To adjust window "in or out" at belt line,
loosen front guide upper adjusting stud nuts,
adjust studs in or out as required, and tighten
stud nuts.
3. To adjust top of window "in or out", loosen
front guide lower adjusting stud nuts, adjust
studs in or out as required, and tighten stud
nuts.
4. To relieve a "fore or aft" binding condition
between front and rear guides, loosen rear
guide adjusting stud nut. Operate window to
"full-down" position and tighten remaining
stud nut.
5. To limit up-travel of window, adjust window
stop as required (see Fig. 7-25 and 7-26).
NOTE:
Adjustments on regulator lift arm cam
are provided to permit maximum travel but cau-
tion must be observed so not to interfere with
quarter trim assembly at belt.
C. REMOVAL AND INSTALLATION-
"E-47" Styles
1. Remove rear quarter window lower garnish
molding.
2. Remove inner panel cam adjusting stud nuts
and turn studs inboard sufficiently to clear
rear quarter inner panel (See Fig. 7-30).
3. Remove lock pillar sealing strip (rubber flap at
belt line).
4. With quarter window fully forward, disengage
inner panel cam from window rollers by sliding
cam rearward. Remove cam from body.
B. REMOVAL AND INSTALLATION-
"E-87" Styles
1. With window in a full-up position, remove rear
guide upper and lower attaching bolts. Disen-
gage guide from roller on window assembly and
remove guide through access hole (see Fig.
7-28).
5. Remove nut securing regulator lift arm to win-
dow vertical sash channel glass roller (see
Fig. 7-30). Disengage lift arm from roller
stud. Remove stud from top of vertical sash
channel cam (see Fig. 7-31).
6. Pull glass forward and remove inboard of side
roof rail.
Advertisement
