Advertisement
SEATS
15-5
ADJUSTER BOLT
ASSIST SPRING
LOCKING WIRE
TENSION HOOK.,-
HOLES FOR TENSION ADJUSTMENT
1173
Fig. 15-3—Manually Operated Seat Adjuster Installation - "B & C" Shown " A , F, X & Z " Typical
SEAT ASSEMBLY
Removal and Installation
1. Operate seat to full forward position. On four -
way or six-way power seats operate seat to
full up position.
2. Remove both driver and passenger inner seat
belt floor pan attaching bolt. Remove seat
cushion side panels where present. Where seat
adjuster track covers are present carefully
pry out track cover snap in retainers with a
flat-bladed tool and remove track covers.
3. Where necessary, remove sill plates and turn
back floor mat or carpeting to expose seat
adjuster-to-floor pan attaching nuts or bolts.
4. Remove seat adjuster-to-floor pan rear at-
taching bolts (Fig. 15-1 or 15-2); then operate
seat assembly to full rearward position.
5. Operate
s e a t
to f u l l
rearward position.
Remove adjuster-to-floor pan front attaching
bolts (Fig. 15-2). Tilt seat assembly rear-
ward sufficiently to disconnect seat harness
feed connector and detach harness from clip
on floor pan. On styles with seat back cigar
lighter, seat back courtesy lamps or seat
back vanity lamp disconnect electrical feed
wire or wires. With aid of a helper remove
seat assembly from body
6. To install seat assembly, reverse removal
procedure. Where seat adjuster-to-floor pan
spacers were present reinstall spacers in
same position.
Make sure ground wire is
securely attached under left seat adjuster-to-
floor pan rear attaching bolt. Check for proper
operation of seat adjusters to limits of travel.
IMPORTANT:
When installing seat assembly
in body, seat adjusters should be parallel and
"in phase" with each other. In the event the
adjusters are "out of phase'' (this is, one ad-
juster reaches its maximum horizontal or
vertical travel in a given direction before the
other adjuster), proceed as follows:
Advertisement
