Advertisement
DOORS
6-79
DOOR WEDGE PLATE - DOOR SIDE
B
VIEW A
DOOR WEDGE PLATE
- BODY SIDE
INTERFERENCE BETWEEN
WEDGE PLATES SHOULD
BE 1 / 3 2 OF A N INCH
V I E W B
SECTION C-C
1656
Fig. 6-106-Door Wedge Plates - " 6 7 " Styles
door locks simultaneously unlock.
When either
valve is actuated downward, all door locks lock.
Vacuum is supplied to the selector valve in the red
color-coded hose and is present at all times at both
valves. Only when the selector valve is actuated is
vacuum supplied to the balance of the system (Fig.
6-107).
FRONT DOOR VACUUM LOCK
SELECTOR VALVES
Removal and Installation
1. Remove door trim pad and carefully disconnect
vacuum hose from selector valve.
2. Carefully disengage valve assembly from door
trim assembly.
3. To install, reverse removal procedure. When
installing vacuum hoses to selector valve, hose
color codes must be installed to the proper
connection on the selector valve for proper
valve operation. Check all operations of door
lock vacuum system prior to installing door
trim and inside hardware.
VACUUM DOOR LOCK ACTUATOR
The actuators that operate the locks are double
acting vacuum diaphragms. Vacuum is supplied to
either side of the diaphragm to lock or unlock the
door lock assemblies. The diaphragm moves a rod
that operates the locking lever of the lock to the
desired position. All vacuum hoses and their cor-
responding actuator ports are color-coded to as-
sure correct hose-to-actuator installation. The
orange coded vacuum hose provides the unlocking
cycle of the door assembly and the yellow coded
vacuum hose provides the locking cycle of the door
lock assembly.
As the actuator is attached to the door lock with
Advertisement
