Advertisement
15-28
SEATS
2. Remove two screws securing bottom of seat
back panel to seat back frame (Fig. 15-33).
3. Pull bottom of seat back panel outward and lift
panel upward to disengage panel from upper
retainers; then, remove panel from seat back.
4. To install seat back panel, reverse removal
procedure. Check for proper operation of seat
back lock.
STRATO FRONT SEAT BACK PANEL-
Two-Door Styles with Folding Seat Back
Removal and Installation
1. Remove seat back lock push button escutcheon
attaching screws and remove push button e s -
cutcheon, push button and ferrule (Fig. 15-34).
2. If seat back is equipped with head rest, de-
press retaining springs and remove head rest
from seat back.
3. Tilt seat back forward and remove two screws
securing bottom of seat back panel to seat back
frame (See Fig. 15-33).
4. Pull bottom of seat back panel outward and lift
panel upward to disengage panel from upper
retainers; then, remove panel from seat back.
5. To install seat back panel, reverse removal
procedure.
n
S EAT BACK
PANEL
SEAT BACK PANEL
UPPER RETAINERS
HEAD
HEAD REST SUPPORTS
REST
1
2250R
SEAT BACK PANEL
FERRULE
PUSH BUTTON
ESCUTCHEON
2539
Fig. 15-33 —Strato Seat Back Panel and Headrest
Fig. 15-34 —Strato Seat Back Lock Push Button
STRATO SEAT BACK HEADREST
Description
All reclining seat backs are equipped with a head-
rest which is adjustable to four different positions.
The Strato headrest is also available as an option
on all Strato design seats on either the drivers or
passengers seat back. When desired, the headrest
can be removed from the seat back by depressing
the
retaining spring at each headrest support
finishing escutcheon (See Fig. 15-35) and pulling
each side of headrest up past the locked position.
STRATO SEAT BACK HEADREST
SUPPORT GUIDE TUBE
Removal and Installation
1. Remove headrest assembly from seat back.
2. Remove support finishing escutcheon screw and
remove escutcheon (Fig. 15-35).
3. Carefully pull plastic support guide tube out of
support. If guide tube hangs up on detent spring
insert a screwdriver into guide and depress
detent spring sufficiently to remove guide tube.
4. To install support guide tube reverse removal
procedure. Make certain lower end of plastic
guide is inserted into hole in bottom of support
and that cut out in guide for detent spring is
Advertisement
