Advertisement
SEATS
15-27
"STRATO" FRONT SEAT BACK ASSEMBLY
(RIGHT OR LEFT)—Full Width Seat-
16639 Style
Removal and Installation
1. Remove seat assembly from body, as previ-
ously described, and place seat right side up
on a clean surface.
2. Remove seat side panel on side from which
seat back is being removed. Remove hog rings
securing seat cushion trim side facing at rear
of seat and turn side facing forward suffi-
ciently to expose seat back outer arm attaching
bolts (Fig. 15-31).
3. Using a suitable hooked end tool between seat
back and seat cushion, at location "A", remove
retaining ring locking seat back at inner hinge
(see View "A", Fig. 15-32).
4. Remove seat back outer arm attaching bolts
(Fig. 15-31).
5. Carefully tilt seat back forward. Remove inner
hinge bolt cover plate. Remove inner hinge
bolts (Fig. 15-32) and carefully remove seat
back from seat assembly.
6. To install, reverse removal procedure.
NOTE:
It is important that removal procedure
is reversed step by step when installing seat
back assembly.
STRATO FRONT SEAT BACK PANEL-
Four-Door Styles with Non-Folding Seat Back
Removal and Installation
1. Remove front seat assembly and front seat
back assembly as previously described.
INNER HINGE
BOLTS
INNER HINGE
LOCK-UP PIN
INNER HINGE ARM
INNER HINGE
LOCK-UP PIN
VIEW A
2297
Fig. 15-32 — Strato Full Width Seat Back Attachment - Chevrolet 16639 Style
Advertisement
