Advertisement
SEATS
15-15
lower adjuster channels. Re-adjust actuator
•'as required" until all free motion between
channels has been removed.
Be sure seat
adjusters
are
"in phase", before installing
seat assembly into body. (See step 6 under
' • F r o n t
S e a t
A s s e m b l y - Removal and
Installation").
FRONT VERTICAL GEARNUT-"B-C & E" Body
Removal and Installation
1. Operate
seat to either full forward or full
rearward position.
2. Remove front
seat assembly from body as
previously described and place upside down on
a clean protected surface.
3. Detach three power drive cables from adjuster
to be removed.
4. Remove screws securing seat adjuster to seat
bottom frame and remove adjuster from seat
assembly.
5. At top of adjuster, remove front vertical gear-
nut attaching nut.
6. Remove front
vertical gearnut spring (Fig.
15-13).
7. Lay adjuster
on its side and remove front
vertical gearnut attaching screws (Fig. 15-14);
then remove gearnut from adjuster.
8. If front vertical gearnut is being replaced with
a new part, transfer gearnut washer to new
gearnut assembly (Fig. 15-13).
9. To install,
reverse removal procedure. Be
sure adjusters are "in phase" before install-
ing seat assembly into body. (See step 6 under
" F r o n t
S e a t
A s s e m b l y - Removal and
Installation").
REAR VERTICAL GEARNUT-"B-C & E" Body
Removal and Installation
1. Operate seat to full forward position.
2. Remove front
seat assembly from body as
previously
described and place upside down
on a clean protected surface.
3. Detach three power drive cables from adjuster
to be removed.
4. Remove screws securing seat adjuster to seat
bottom frame and remove adjuster from seat
assembly.
5. At top of adjuster, remove rear vertical gear-
nut attaching nut (Fig. 15-13).
6. Lift rear of channel upward and remove rear
vertical gearnut spring (Fig. 15-13).
7. Lay adjuster
on its side and remove rear
vertical gearnut attaching screws; then remove
gearnut from adjuster (Fig. 15-14).
8. If rear vertical gearnut is being replaced with
a new part, transfer gearnut washer to new
gearnut assembly (Fig. 15-13).
9. To install,
reverse removal procedure. Be
sure rear gearnut spring is properly engaged
under adjuster upper channel before tightening
rear gearnut upper attaching nut. In addition,
be sure adjusters are "in phase" prior to in-
stalling seat assembly into body. (See step 6
under "Front Seat Assembly - Removal and
Installation").
Fig. 15-14— Six-Way Seat Adjuster Components -
" B & C " Styles
A. Upper Channel Assembly
B. Rear Vertical Gearnut
Attaching Screws
C. Lower Channel
D. Rear Spring
E . Rear Gearnut
Attaching Nut
F . Actuator Attaching
Screws
G . Front Vertical Gearnut
Attaching Screws
H . Plastic Shoe
1 . Actuator Locating
Spring
J . Horizontal Actuator
K . Front Spring
L . Front Gearnut
Attaching Screw
Advertisement
