Advertisement
15-30
SEATS
TURN BACK
CUSHION SIDE
CUSHION SIDE
PANEL SUPPORT
TRIM
Fig. 15-36 —Bucket Seat Back Removal (Without
Reclining Seat Back) - All Except Corvair
4. To install seat back lock, lock control or lock
rod, reverse removal procedure. Make certain
lock rod and clips are properly engaged and
locked at lock lever and lock control lever.
Check for proper operation of seat back lock.
RECLINING FRONT SEAT BACK
DESCRIPTION
The reclining seat back which is available on the
passenger seat of the Strato design front seats can
be reclined approximately 30 degrees from the
normal seat back position. The reclining unit is a
friction operating mechanism and is actuated by a
control handle and cable at the right side of the
seat.
When the control handle is pulled upward the con-
trol cable unlocks the reclining positioning unit in
the seat back allowing the seat back to be reclined,
by means of rearward pressure on the seat back,
to a maximum of approximately 30 degrees or until
the control handle is released. When the control
handle is released the reclining positioning unit is
locked and will not allow the seat back to be re-
clined further. When the control handle is pulled
up and there is no rearward pressure on the seat
back, the assist spring in the reclining positioning
SEAT BACK
LOCK CONTROL
SEAT BACK
LOCK STRIKER
LOCK ROD
LOCK ROD CLIP
ENGAGED
LOCK ROD CLIP
DISENGAGED
J B
VIEW A
SEAT BACK HINGE
(BUCKET SEAT)
SEAT BACK HINGE
FULL WIDTH SEAT
VIEW B
2457
Fig. 15-37 —Seat Back Lock, Lock Control and Lock Rod - Strato Full Width and Bucket Seats
Advertisement
