Advertisement
ELECTRICAL
16-39
Fig. 16-62-Horizontal Bench Seat Wiring
1. Front Seat Back Switch
Feed - White
2. Front Seat Back Switch
Ground - Black
3. Control Switch
4. Harness Feed
Connector
5. Motor
6. Ground Wire
7. Front Seat Back
Courtesy Lamp
Feed Connector
(Cadillac Only)
8. Horizontal Control Cable
1. Wiring to Door
Arm Rest Switch
2. Feed Harness
Connector
proper attachme
in the circuit. If the location of the failure is evi-
dent, follow only the steps required to check the
affected wire or component. If the location of the
failure is not evident, follow the procedure as out-
lined. Before performing any extensive check pro-
cedures, check the seat adjuster drive cables for
Fig. 16-63—Horizontal Bench Seat Wiring -
Buick and Oldsmobile " C " Body
3. Control Cable
4. Seat Motor
5. Ground Wire
cuit diagrams to become familiar with the seat
circuit. See Figures 16-75, 16-76 and 16-77.
a. Checking Feed Circuit Continuity
at Circuit Breaker
1. Connect one test light lead to battery side of
ORANGE-BLACK STRIPE
TO IGNITION
TERMINAL ON
FUSE BLOCK
o
RELAY
FORWARD CYCLE
DARK GREEN
4 0 AMP.
CIRCUIT BREAKER
NOTE.
CONNECTOR USED ONLY
WHEN SWITCH IS ON ARM REST
SEAT MOTOR
REARWARD CYCLE-YELLOW
FEED-RED-WHITE STRIPE
1817
Fig. 16-64-Horizontal Seat Circuit - Oldsmobile Styles
Advertisement
