Advertisement
HEADLINING
11-3
3.
4.
FINISHING PANEL
TYPICAL RETAINING CLIP
-TACKING STRIP
2156
Fig. 11 -2 — Upper Quarter Trim Installation
j . Upper quarter trim
styles so equipped).
finishing panel (on
k. Back body opening garnish moldings or
finishing lace.
1. Shoulder strap anchor plate and escutcheon.
Carefully remove tacks or staples securing
headlining at windshield and back window open-
ing or back body opening.
On styles using pronged retainers, use head-
lining inserting tool, J-2772 or similar wide-
bladed tool and carefully disengage headlining
from pronged retainers where present.
5. Carefully detach cemented edge of headlining
around entire perimeter.
6. Starting at front of body, carefully disengage
No. 1 and No. 2 listing wires from side roof
inner rails and supporting tabs on longitudinal
(front to rear) bow on styles so equipped
(View "D" in Fig. 11-1). In like manner,
working from rear of body, disengage listing
wires from side roof rails and supporting tabs
on longitudinal bow. Exercise care to keep
headlining material clean by gathering or fold-
ing headlining with listing wires on outside.
7. At No. 3 listing wire, bend down tab securing
listing wire (View "C" in Fig. 11-1) and re-
move headlining assembly from body.
Fig. 11-3 — Pinchweld Finishing Lace
IMPORTANT:
Note
in which holes listing
wires are installed in side roof rails. Listing
wires should be placed in same hole when re-
placing headlining.
8. If replacing headlining, remove listing wires
from pockets of old headlining.
IMPORTANT:
Listing wires removed from
old headlining must be installed in correspond-
ing pockets of new headlining.
INSTALLATION
1. If previously removed, install listing wires
into corresponding pockets of new headlining
assembly.
2. Apply approved trim cement to headlining at-
taching surface at windshield, side roof rail
and back window or back body opening. On
styles that utilize pinchweld finishing lace be
certain cement is applied to both sides of re-
tainer at windshield and back window or back
body opening. (View "E", Fig. 11-1 and Fig.
11-5).
3. Lift headlining assembly into body and install
No. 3 listing wire and listing wire pocket over
metal tab at roof bow (View "C", Fig. 11-1).
Bend up tab to secure listing wire to bow.
Make certain headlining is centered in body.
4. When new headlining is being installed on
styles equipped with longitudinal bow (except
cloth headlining) slit listing wire pockets at
each tab location on longitudinal bow (approxi-
mately 1-1/2" in length). Working rearward
from No. 3 listing wire, install listing wires
in side roof rails and over tabs on longitudinal
Advertisement
