Air Conditioner And Heater Control Assembly-Removal And Installation - Jeep cherokee 1989 Owner's Manual

Chapter
3-12
connections are located next to the battery
16.4 Remove the four air conditioning control panel
mounting screws (arrows)
16.5 Unplug the electrical connectors
The Motor Manual Guy
3
Cooling, heating and air conditioning systems
6
lustration).
7
dirt and moisture out.
8
fittings on top t o prevent oil from draining out.
9
10 Reinstall the components in the reverse order of removal. Be sure
the rubber pads are in place under the condenser.
1 1 Have the system evacuated, recharged and leak tested by the shop
that discharged it.
1 6 Air conditioner and heater control assembly
Refer to illustrations 16.4, 16.5, 16.6, 16.7 and 16.8
1
On four-cylinder and V6 models, remove the screws
(arrows) and pull off the cover to reach the mounting bolts
Remove the mounting bolts from the condenser brackets (see il-
Lift the condenser out of the vehicle and plug the lines to keep
If the original condenser will be reinstalled, store it with the line
If a new condenser is being installed, pour one ounce of refrigerant
and installation
Disconnect the negative cable from the battery.
16.6 Bend back the locking tab to release the
vacuum connector
-
removal