BATTERYICHARGING SYSTEM
REMOVAUINSTALLATION
Remove the right side cover (page
3-~
With the ignition switch turned to OFF, disconnect
the regulator/rectifier 5P connector.
Remove the nuts, regulator/rectifier and spacer.
Install the regulator/rectifier in the
rev~rse
order of
removal.
ALTERNATOR CHARGING COIL
INSPECTION
Remove the seat (page 3-3).
With the ignition switch turned to OFF, disconnect
the alternator 3P (Natural) connector.
Measure the resistance between the Yellow wire
terminals of alternator/stator side connector.
STANDARD: 0.1 - 1.0
n
at
20°C (68°F)
Check for continuity between each wire terminals of
the alternator/stator side connector and ground.
There should be no continuity.
Replace the stator if the resistance is out of specifi
cation, or if any wire has continuity to ground.
For alternator/starter replacement (page
12~4).
18-9