Configuring Upper-Layer Protocols Over Static Ethernet Interfaces; Module Requirements; Interface Specifiers; Upper-Layer Protocols Over Static Ethernet References - Juniper JUNOSE SOFTWARE 11.2.X - LINK LAYER CONFIGURATION GUIDE 7-7-2010 Configuration Manual

Module Requirements

Interface Specifiers

Upper-Layer Protocols over Static Ethernet References

Configuring IP over a Static Ethernet Interface

Copyright © 2010, Juniper Networks, Inc.
Chapter 4: Configuring Upper-Layer Protocols over Static Ethernet Interfaces
For information about the modules supported on E Series routers:
See the ERX Module Guide for modules supported on ERX7xx models, ERX14xx models,
and the ERX310 router.
See the E120 and E320 Module Guide for modules supported on the E120 and E320
routers.
The configuration task examples in this chapter use the format for ERX7xx models,
ERX14xx models, and the ERX310 router to specify a VLAN or S-VLAN subinterface.
For ERX7xx models, ERX14xx models, and ERX310 router, use the slot/port[.subinterface
] format. For example, the following command specifies a VLAN subinterface configured
on port 0 of an I/O module in slot 4.
host1(config)#interface fastEthernet 4/0.1
For E120 and E320 routers, use the slot/adapter/port[.subinterface ] format, which includes
an identifier for the bay in which the I/O adapter (IOA) resides. For example, the following
command specifies a VLAN subinterface configured on port 0 of the IOA installed in the
upper adapter bay of slot 3.
host1(config)#interface gigabitEthernet 3/0/0.1
For more information about interface types and specifiers on E Series models, see Interface
Types and Specifiers in JunosE Command Reference Guide.
For more information about upper-layer protocol implementations over Ethernet, consult
the following resources:
RFC 894—A Standard for the Transmission of IP Datagrams over Ethernet Networks
(April 1984)
RFC 1042—A Standard for the Transmission of IP Datagrams over IEEE 802 Networks
(February 1988)
RFC 1112—Host Extensions for IP Multicasting (August 1989)
RFC 2516—Method for Transmitting PPP over Ethernet (PPPoE) (February 1998)
To configure IP over an Ethernet interface:
Specify a Fast Ethernet, Gigabit Ethernet, or 10-Gigabit Ethernet port.
1.
host1(config)#interface fastEthernet 4/1
Create an IP interface.
2.
153