Table 170: Aggregated Ethernet Interface Options - Juniper JUNOS OS 10.3 - SOFTWARE Manual

Table 170: Aggregated Ethernet Interface Options

Field
Aggregated Interface
LACP Mode
Description
Interface
Enable Log
Copyright © 2010, Juniper Networks, Inc.
—Specifies IP options for the selected LAG. Enter information as specified
IP Option
in Table 172 on page 1160.
Delete —Deletes the selected LAG.
or
Disable Port Enable Port
selected interface.
Device Count —Configures the number of aggregated logical devices available to
the switch. Select the number and click
Function
Specifies the name of the aggregated
interface.
Specifies the mode in which LACP
packets are exchanged between the
interfaces. The modes are:
—Indicates that no mode is
None
applicable.
—Indicates that the interface
Active
initiates transmission of LACP packets
—Indicates that the interface
Passive
responds only to LACP packets.
Specifies a description for the LAG.
Specifies the interfaces in the LAG.
Specifies whether to enable generation
of log entries for the LAG.
—Disables or enables the administrative status on the
.
OK
Your Action
None. The name is supplied by the
software.
Select from the list.
Enter a description.
To add interfaces to the LAG, select the
interfaces and click
To remove an interface from the LAG,
select the interface and click
NOTE: Only interfaces that are
configured with the same speed can be
selected together for a LAG.
Select the check box to enable log
generation, or clear the check box to
disable log generation.
Chapter 52: Configuring Interfaces
. Click .
Add OK
Remove .
1159