Configuring Interface Routes (Nsm Procedure) - Juniper NETWORK AND SECURITY MANAGER - NSM CONFIGURATION GUIDE FOR EX SERIES DEVICES REV 3 Configuration Manual

Table 51: Configuring Martian Address Fields (continued)
Option
Exact

Configuring Interface Routes (NSM Procedure)

82
Function
Specifies match criteria for the route's
mask length with the martian address.
The criteria are:
Exact
Longer
Orlonger
Upto
Through
Prefix Length Range
You can associate a routing table group with the device's interfaces and specify routing
tables into which interface routes are imported. To define the routing tables into which
interface routes are imported, you create a routing table group and associate it with the
device's interfaces.
To configure interface routes in NSM:
In the navigation tree, select
1.
In the list, double click the device to select it.
Devices
2.
Click the Configuration
3.
In the configuration tree, expand
4.
Select Interface Routes
5.
Add or modify the parameters as specified in Table 52 on page 83.
6.
Click one:
7.
OK—To save the changes.
Cancel—To cancel the modifications.
Apply—To apply the routing option settings.
NOTE: After you make changes to a device configuration, you must push that
updated device configuration to the physical security device for those changes
to take effect. You can update multiple devices at one time. See the Updating
Devices section in the Network and Security Manager Administration Guide for
more information.
Your Action
1.
2. Expand the
3. Enter the match criteria.
Device Manager > Devices
tab.
Routing Options
.
Click the New button or select a
martian address and click the Edit
button.
tree and select
Martian
.
Exact
.
.
Copyright © 2010, Juniper Networks, Inc.