Related
Documentation
Configuring NSRP to Detect Interface and Zone Failure
Copyright © 2010, Juniper Networks, Inc.
Figure 7: Configuring VSD Group Masters
Click OK to save your changes to the cluster.
5.
NSRP Clusters Overview on page 363
Creating an NSRP Cluster on page 365
Active/Active Configurations Overview on page 370
Changing VSD Group Member States (NSM Procedure) on page 373
Configuring NSRP to Detect Interface and Zone Failure on page 375
You can configure NSRP to detect interface and zone failures on a device or VSD group.
When one or more monitored objects on a device or VSD group fail, the primary device
in the cluster or VSD group can fail over to the backup device or VSD group.
To control when the device or VSD group fails over, you configure the device to monitor
specific objects.
Chapter 13: High Availability
375