Configuring Infranet Controller Source Interface Policies (Nsm Procedure) - Juniper NETWORK AND SECURITY MANAGER 2010.4 - CONFIGURING INFRANET CONTROLLER GUIDE REV 01 Manual

Related
Documentation

Configuring Infranet Controller Source Interface Policies (NSM Procedure)

Copyright © 2010, Juniper Networks, Inc.
Table 29: IP Address Pool Policy Configuration Details (continued)
Option
Applies to roles
Table 30: Syntax for IP Address Pools
IP Address Range
a.b.c.d
a.b.c.d-e.f.g.h
a.b.c.d-f.g.h
a.b.c.d-g.h
a.b.c.d-h
a.b.c.d/mask
Configuring Infranet Controller IPsec Routing Policies (NSM Procedure) on page 95
Configuring Infranet Enforcer Resource Access Policies (NSM Procedure) on page 93
A source interface policy specifies the source interface on the Infranet Enforcer that
receives traffic from endpoints. The use cases for configuring source interface policies
are limited.
Chapter 10: Configuring Infranet Enforcer Policies
Function Your Action
Specifies the policies that
apply to the roles.
NOTE: Select the policies from the
Non-members list and click Add to
move it to the Members list before
applying the policies to the roles.
Description
Specifies a single IP address.
Specifies all IP addresses from the first address to the last
address, inclusive.
Specifies the range a.b.c.d through a.f.g.h.
Specifies the range a.b.c.d through a.b.g.h.
Specifies the range a.b.c.d through a.b.c.h.
Specifies all addresses in a network.
Select Policy applies to ALL roles
to apply this Infranet Controller IP
address pool policy to all users.
Select Policy applies to SELECTED
roles to apply this Infranet
Controller IP address pool policy
only to users who are mapped to
roles in the Members list.
Select Policy applies to roles
OTHER THAN those selected to
apply this Infranet Controller IP
address pool policy to all users
except those who map to the roles
in the Members list.
99