Configuring A Router Or Interface To Act As A Bootstrap Protocol Relay; Agent; Table 100: Bootp Configuration Details - Juniper NETWORK AND SECURITY MANAGER 2010.4 - M-SERIES AND MX-SERIES DEVICES GUIDE REV 1 Manual

M-series and MX-series Devices
Configuring a Router or Interface to Act as a Bootstrap Protocol Relay Agent
198
Configuration Protocol (DHCP) or Bootstrap Protocol (BOOTP) relay agent. You use
only one server address per interface or global configuration. See the following topics:
Configuring a Router or Interface to Act as a Bootstrap Protocol Relay Agent on page 198
Enabling DNS Request Packet Forwarding on page 201
Configuring a Port for a DHCP or BOOTP Relay Agent on page 203
Configuring Tracing Operations for BOOTP, DNS, and TFTP Packet
Forwarding on page 204
You can configure a router or interface to act as a Dynamic Host Configuration Protocol
(DHCP) or bootstrap protocol (BOOTP) relay agent using this option.
To configure a BOOTP relay agent in NSM:
In the NSM navigation tree, select Device Manager > Devices.
1.
Click the Device Tree tab, and then double-click the device to select it.
2.
Click the Configuration tab. In the configuration tree, expand Forwarding Options >
3.
Helpers > BOOTP.
Add or modify settings as specified in Table 100 on page 198.
4.
Click one:
5.
OK—Saves the changes.
Cancel—Cancels the modifications.

Table 100: BOOTP Configuration Details

Task
Configures a router or interface
to act as a DHCP or BOOTP relay

agent.

Your Action
1. In the Comment box, enter the comment.
2. Select the Relay Agent check box to configure router as a
BOOTP relay agent.
3. From the Maximum Hop Count list, select the maximum
number of hops allowed.
Default: 4 hops
4. From the Minimum Wait Time list, select the minimum
time allowed.
Default: 3 seconds
5. From the Client Response Ttl list, select the IIP time-to-live
(TTL) value in DHCP response packets sent to a DHCP
client.
Copyright © 2010, Juniper Networks, Inc.