RZ/A1L Group, RZ/A1LU Group, RZ/A1LC Group
22.6.5
Slave transmission (single mode)
START
Set up the IEBBnPSR, IEBBnUAR,
IEBBnCKS, and IEBBnTMS registers.
Set the IEBBnBCR register to 80H.
Set up the IEBBnDLR,
IEBBnDR (first byte of data) registers.
Set the IEBBnBCR register to 90H
(separate communication).
Has IEBBTSTA
occurred (IEBBTV)?
Start interrupt servicing
(See 22.5.7 (3) "Interrupt servicing example".)
Has IEBBTD occurred?
Has IEBBTSTA
occurred (IEBBTV)?
End interrupt servicing
(See 22.5.7 (3) "Interrupt servicing example".)
END
Figure 22-48 Slave transmission (single mode): When the control bit 3H or 7H is
R01UH0437EJ0600 Rev.6.00
Jan 29, 2021
(1)
When the control bit 3H or 7H is received
No
: Start interrupt occurrence check
Yes
Yes
: Data interrupt occurrence check
No
No
: End interrupt occurrence check
Yes
received
: Initial settings
: Slave transmission enable
Set up the IEBBnDR register.
22. IEBus Controller
: Specify the 2nd
and following
bytes of data.
22-103