Show Wan And Wwan Status And Statistics - Digi IX30 User Manual

Interfaces
The default setting is primary.
15. Optional IPv6 configuration items:
a. IPv6 support is enabled by default. To disable:
(config network interface my_wwan)> ipv4 enable false
(config network interface my_wwan)>
b. Set the metric:
(config network interface my_wwan)> ipv4 metric num
(config network interface my_wwan)>
See Configure WAN/WWAN priority and default route metrics
metrics.
c. Set the relative weight for default routes associated with this interface. For multiple active
interfaces with the same metric, the weight is used to load balance traffic to the interfaces.
(config network interface my_wwan)> ipv4 weight num
(config network interface my_wwan)>
d. Set the management priority. This determines which interface will have priority for central
management activity. The interface with the highest number will be used.
(config network interface my_wwan)> ipv4 mgmt num
(config network interface my_wwan)>
e. Set the MTU:
(config network interface my_wwan)> ipv4 mtu num
(config network interface my_wwan)>
f. Configure when the WWAN's DNS servers will be used:
(config network interface my_wwan)> ipv4
(config network interface my_wwan)>
Where value is one of:
n
n
n
The default setting is primary.
g. See Configure SureLink active recovery to detect WAN/WWAN failures
about configuring active recovery.

Show WAN and WWAN status and statistics


Web
IX30 User Guide
always: DNS will always be used for this WWAN; when multiple interfaces have the
same DNS server, the interface with the lowest metric will be used for DNS
requests.
never: Never use DNS servers for this WWAN.
primary: Only use the DNS servers provided for this WWAN when the WWAN is the
primary route.
Wide Area Networks (WANs)
for further information about
dns value
for information
145