Table of Contents
Advertisement
Interfaces
d. Set the management priority. This determines which interface will have priority for central
management activity. The interface with the highest number will be used.
(config network interface my_wwan)> ipv4 mgmt num
(config network interface my_wwan)>
e. Set the MTU:
(config network interface my_wwan)> ipv4 mtu num
(config network interface my_wwan)>
f. Configure when the WWAN's DNS servers will be used:
(config network interface my_wwan)> ipv4
(config network interface my_wwan)>
Where value is one of:
n
n
n
The default setting is primary.
g. See
Configure SureLink active recovery to detect WAN/WWAN failures
about configuring active recovery.
Show WAN and WWAN status and statistics
WebUI
1. Log into the Connect EZ WebUI as a user with Admin access.
2. From the menu, click Status.
3. Under Networking, click Interfaces.
Command line
1. Log into the Connect EZ command line as a user with Admin access.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. Enter the
show network
> show network
Interface
----------------
defaultip
defaultlinklocal
Digi Connect EZ 4/4i User Guide
always: DNS will always be used for this WWAN; when multiple interfaces have the
same DNS server, the interface with the lowest metric will be used for DNS
requests.
never: Never use DNS servers for this WWAN.
primary: Only use the DNS servers provided for this WWAN when the WWAN is the
primary route.
command at the Admin CLI prompt:
Proto
Status
-----
-------
IPv4
up
IPv4
up
Wide Area Networks (WANs)
dns value
Address
-------------------------------
192.168.210.1/24
169.254.100.100/16
for information
123
Advertisement
Table of Contents
