Show Wan And Wwan Status And Statistics - Digi IX20-WAG4 User Manual

Interfaces
The default setting is primary.
g. See Configure SureLink active recovery to detect WAN/WWAN failures
about configuring active recovery.

Show WAN and WWAN status and statistics


WebUI
1. Log into the IX20 WebUI as a user with Admin access.
2. From the menu, click Status.
3. Under Networking, click Interfaces.

Command line
1. Log into the IX20 command line as a user with Admin access.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. Enter the show network
> show network
Interface
----------------
defaultip
defaultlinklocal
eth1
eth1
eth2
eth2
loopback
modem
modem
>
3. Additional information can be displayed by using the
> show network verbose
Interface
Weight
----------------
----
defaultip
defaultlinklocal
eth1
eth1
eth2
eth2
IX20 User Guide
command at the Admin CLI prompt:
Proto Status Address
----- ------- -------------------------------
IPv4 up 192.168.210.1/24
IPv4 up 169.254.100.100/16
IPv4 up 10.10.10.10/24
IPv6 up fe00:2404::240:f4ff:fe80:120/64
IPv4 up 192.168.2.1/24
IPv6 up fd00:2704::1/48
IPv4 up 127.0.0.1/8
IPv4 up 10.200.1.101/30
IPv6 down
Proto Status Type
----- ------- ------
IPv4 up static
IPv4 up static
IPv4 up dhcp
IPv6 up dhcp
IPv4 up static
IPv6 up static
Wide Area Networks (WANs)
for information
show network verbose command:
Zone Device
-------- --------
setup eth2
setup eth2
external eth1
external eth1
internal eth2
internal eth2
Metric
------ --
10 10
0 10
1 10
1 10
5 10
5 10
125