Configure Power Management Mode - Digi Connect IT 4 User Manual

Serial port
17. Save the configuration and apply the change:
(config)> save
Configuration saved.
>
18. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.

Configure Power Management mode

Power Management mode allows you to configure the port for use with a power controller.
For additional information about configuring the feature, see
To change the configuration to match the serial configuration of the device to which you want to
connect:

Web
1. Log into the Connect IT 4 WebUI as a user with Admin access.
2. On the menu, click System. Under Configuration, click Serial Configuration.
The Serial Configuration page is displayed.
Note You can also configure the serial port by using Device Configuration > Serial. Changes
made by using either Device Configuration or Serial Configuration will be reflected in both.
3. Click the name of the port that you want to configure.
The serial port is enabled by default. To disable, toggle off Enable.
4. For Mode, select Power Management.
Digi Connect IT® 4 User Guide
Configure Power Management mode
Configure Remote Power Management.
229