Table of Contents
Advertisement
Wi-Fi
3. Set channel for the radio:
a. Set the band for the radio:
(config)> network wifi radio phy0 band value
(config)>
where value is either 2400mhz or 5000mhz.
b. Set the mode for the Wi-Fi radio. For example:
n
n
4. Save the configuration and apply the change:
(config)> save
Configuration saved.
>
5. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
Configure the Wi-Fi radio's transmit power
The default Wi-Fi transmit power that the Wi-Fi radio will use when in access point or client mode is
100 percent. You can configure the Wi-Fi radio to transmit at a lower power.
WebUI
1. Log into the IX20 WebUI as a user with full Admin access rights.
2. On the menu, click System. Under Configuration, click Device Configuration.
The Configuration window is displayed.
IX20 User Guide
If the Wi-Fi radio has a band of 2400mhz:
(config)> network wifi radio phy0 2400mhz mode value
(config)>
where value is one of b, bg, bgn, g, gn, or n.
If the Wi-Fi radio has a band of 5000mhz:
(config)> network wifi radio phy0 5000mhz mode value
(config)>
where value is one of ac, acn, or n.
Configure the Wi-Fi radio's transmit power
192
Advertisement
Table of Contents
