Configure Power Button Behavior - Digi TX54 User Manual

System administration
4. To deactivate the Find Me feature, click System and click Find Me again.
A notification message appears, noting that the LED is no longer flashing on the device. Click
the x in the message to close it.

Command line
1. Log into the TX54 command line as a user with Admin access.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. To activate the Find Me feature, at the prompt, type the following at the command prompt:
> system find-me on
>
3. To deactivate the Find Me feature, type the following at the command prompt:
> system find-me off
>
4. To determine the status of the Find Me feature, type the following at the command prompt:
> system find-me status
off
>

Configure power button behavior

The TX54 device's front panel includes a Power button.
If the device is off, pressing the Power button will turn on the device.
n
If the device is on, the Power button includes two options to power down the device: short-
n
press and long-press options. By default, both short-press and long-press Power button
actions will shut down the device.
You can disable the short-press power down behavior, to prevent powering down the device when the
Power button is accidentally pressed. You can also disable the power button entirely, so that both the
short- and long-press power down behavior is disabled and the device cannot be powered down by
using the Power button.

WebUI
TX54 User Guide
Configure power button behavior
837