Table of Contents
Advertisement
System administration
3. To deactivate the Find Me feature, click System and click Find Me again.
A notification message appears, noting that the LED is no longer flashing on the device. Click
the x in the message to close it.
Command line
1. Select the device in Remote Manager and click Actions > Open Console, or log into the IX40
local command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. To activate the Find Me feature, at the prompt, type the following at the command prompt:
> system find-me on
>
3. To deactivate the Find Me feature, type the following at the command prompt:
> system find-me off
>
4. To determine the status of the Find Me feature, type the following at the command prompt:
> system find-me status
off
>
Configure a power profile
A power profile is a group of settings that determine how the system will behave in terms of power
consumption during standard operating mode. You can choose to preserve power, performance or to
balance both. You can also disable the IX40's LEDs to save power and reduce light pollution.
To change the active power profile:
É
Web
1. Log into Digi Remote Manager, or log into the local Web UI as a user with full Admin access
rights.
2. Access the device configuration:
Remote Manager:
a. Locate your device as described in
device.
b. Click the Device ID.
c. Click Settings.
IX40 User Guide
Use Digi Remote Manager to view and manage your
Configure a power profile
869
Advertisement
Table of Contents
